「鶴崗道閘」廣告道閘安裝流程和步驟

1.機箱固定后，把廣告道閘主桿插進桿把，用六角螺絲和墊片，彈墊，螺母固定好，然后，把閘桿LED燈線，通過主軸孔，引進道閘。

After fixing the chassis, the main rod of the advertising gate into the lever handle, fix it with hexagonal screw and gasket, bullet pad and nut, and then introduce the gate through the main shaft hole through the LED lamp line of the gate.

2.把連桿固定在廣告道閘的機箱背面相應的位置，用螺絲固定。

Fix the connecting rod at the corresponding position on the back of the box of the advertisement gate and screw it.

3.將廣告道閘的副桿與連桿連接在一起，用螺絲固定。

Connect the auxiliary rod and connecting rod of the advertisement gate and fix it with a screw.

4.翻板安裝完成后，將另外的撐桿也插入廣告道閘的主桿與副桿的插槽中。

After the turning board is installed, the other supporting rods into the slots of the main and auxiliary rods of the advertisement gate.

5.將組裝好的廣告道閘的翻板分別插入主桿與副桿的插槽中。

Insert the flip board of the assembled advertisement gate into the slots of the main and auxiliary rods respectively.

6.翻板安裝完成后，將另外的廣告道閘的撐桿也插入主桿與副桿的插槽中。

After the turning board is installed, the brace of the other advertisement gate into the slot of the main and auxiliary poles.

7.撐桿安裝到位后，然后將主桿前封板固定在主桿與副桿上，用螺絲鎖緊，確保廣告道閘發(fā)翻板和撐桿之間不能隨意松動。

After the support rod is installed in place, the front cover plate of the main rod is fixed on the main rod and the auxiliary rod, and the screw is used to lock it, so as to ensure that the flip plate and the support rod of the advertisement channel can not be loosened at will.

8.廣告道閘的閘桿主體部分，安裝調試完成后，可以安裝落地撐桿部分，用螺絲鎖緊。

After installation and commissioning, the main part of the brake rod of the advertisement gate can be installed with the floor brace and locked with a screw.

www.1688ddm.cn

艾經(jīng)理

13940183063